VDIAGTOOL Coating Thickness Gauge VC100 with Digital LCD Backlight Display Measuring Paint Depth Car Paint Tester for Car Accident Detection
VDIAGTOOL Coating Thickness Gauge VC100 with Digital LCD Backlight Display Measuring Paint Depth Car Paint Tester for Car Accident Detection: VDIAGTOOL. Buy VDIAGTOOL Coating Thickness Gauge VC100 with Digital LCD Backlight Display Measuring Paint Depth Car Paint Tester for Car Accident Detection: Specialty - ✓ FREE DELIVERY possible on eligible purchases. The portable OBD2 OBDII coating thickness gauge can meansure the thickness of non-metallic coating(such as paint, film, etc.) on metal substrate quickly, nondestructively and accuratly. . The Car Paint Tester is mainly used to measure the thickness of the vehicle's surface paint and other coating meaurement. . Mini size with digital LCD backlight display. High Quality. Easy to operate and use. . Note: Measurement range at 0-1.80mm/71.0mil, Resolution at 0.05mm/2mil, Measurement error at ±0.1mm. . 1 Year Warranty. Please Note: The paint depth gauge is NOT include the batteries. If you have any questions about the paint thickness gauge, please do not hesitate to contact us. . Technical Parameters:.Measurement Range: 0-1.80mm/71.0mil.Resolution: 0.0mm/2mil.Measurement Error: ±0.1mm.Minimum Diameter of Substrate: Φ0mm.Minimum Thickness of Substrate: 0.mm.Work Temperature Range: 18-30°C.Work Humidity Range: 10-80%RH.Batteries: CR2302*2(NOT included).Outline Dimension: 38*87*22mm.Weight: 63.98g. Button Functions:.1.Button "CLR": Turn on/off, clear..2.Button "UNIT": Unit Switch, backlight..Operation Instructions:.1.Measurement preparation.Open battery cover and load two CR2032 button batteries; Pay attention to positive and negative pole..2.Turn on/off.Leave the instrument hang in the air and press "CLR" button to turn it on, LCD full screen display, which means it enters the measurement state. Then long press"CLR"button to turn it off..Note: Keep it away from the substrate when starting up..3.Measurement.Press the probe onto the coated metal substrate lightly, ensure that the instrument should be perpendicular to the surface of the object that being measured..Note: When the probe was pressed on the substrate, the LCD will display "---" , then you must wait unit the measurement value displayed the LCD, then remove it from the substrate. If removing before a value is displayed, it will display the last measured value...Unit selection.After start-up, short press "UNIT" button to select measurement unit mm or mil...LCD backlight.After start-up, long press "UNIT" button to turn on/off the backlight..6.Clear screen data.After start-up, press "CLR" button to clear the data displayed on LCD screen..7.Power off automatically.The Car Paint Tester will power off automatically if two minutes no operation after start-up. And it will power off automatically as well after five minutes start-up, even when you are operating it.. . . .